• New Delhi, India
  • 011-4161 5459
  • info@khushicomms.com
Ether10.Genius: Multi Technology Tester (10GbE)
You are here: Home \ Ether10.Genius: Multi Technology Tester (10GbE)

Ether10.Genius: Multi Technology Tester (10GbE)

Ether10.Genius the smallest double-port 10GbE tester also includes GbE, 1000/100/10BASE-T, SyncE, PTP, E1, C37.94 and Datacom. All the features field engineers need to turn-up and troubleshoot new LTE networks it is capable to verify both the transmission layer and clocks that synchronize the mobile network. The C37.94 support includes BER and one-way delay ideal for Power Utility companies willing to check the protection of high voltage substations.

You may buy just a last generation dual port 10GbE tester and then you may add other interfaces just when you need it by a simple and easy upgrade by code. Then you will be able to get the new firmware supporting the desired functionalities.

  • No modules: no problems.
  • No modules: all the interfaces are always there.
  • No modules: no silly connectors, perfect connections.
  • No modules: you will never ever lost/forget/broke a module again.

6h. of continuous Operation at 10 Gbit/s

Ether10-Genius-front

  • Double port 10GbE
  • 2 x SFP+
  • C37.94: BER, event gen/ana
  • One-way-delay with GPS
  • ESMC / SSM generation analysis and capture
  • Y.1564 (e-SAM) 2-way FTD, FLR SES, PEU and PEA
  • Y.1731 QoS statistics
  • Sym/Asym RFC2544
  • FCS error insertion
  • L1/L2/L3/L4 loopback
  • Multistreams for IPTV, VoIP, Q-in-Q for demarcation tests
  • MPLS support
  • Scan MAC/IP/VLAN/QinQ
  • SyncE / PTP wander
  • SNMP support
  • Cisco Data Cables

GbE Features

Ether-Genius

  • Y.1564 (e-SAM) FTD, 2-way FDV, FDV, 2-way FTD, FLR, SES, PEU and PEA
  • Y.1731 QoS statistics
  • 2xSFP+, 2xRJ45 interfaces
  • Symmetrical & Asymmetrical RFC2544 test
  • FCS error insertion in pass-through mode
  • L1/L2/L3/L4 loopback
  • Multistreams for IPTV, VoIP, and Critical Data verification
  • Q-in-Q for demarcation tests
  • MPLS support
  • Scan MAC/IP/VLAN/QinQ
  • Advanced Counts: Up to 8 filters at MAC, IP, TCP/UDP, Arbitrary [mask + offset]
  • Migrable to Synchronous Ethernet (SyncE)

SyncE Features

  • Synchronization according G8261, G8262, G8264
  • Ethernet Line frequency (MHz), offset (ppm), drift (ppm/s)
  • Analysis / Generation ESMC messages and SSM count and rate
  • Ext. clock input including 2048 kb/s, 2048 Hz, and Synchronous Ethernet
  • SyncE MTIE / TDEV measurement
  • SyncE Wander analysis/generation
  • PTP / IEEE 1588v2 support decoding
  • PTP support / generation as master or slave
  • Master Clock operation on each port using internal/external ref.
  • Y.1564 (e-SAM) FTD, 2-way FDV, FDV, 2-way FTD, FLR, SES, PEU & PEA
  • Y.1731 QoS statistics
  • 2xSFP + 2 x RJ45 i/faces
  • Symmetrical & Asymmetrical RFC2544 test
  • FCS error insertion in pass-through mode
  • L1/L2/L3/L4 loopback
  • Multistreams for IPTV, VoIP, and Critical Data verification
  • Q-in-Q for demarcation tests
  • MPLS support
  • Scan MAC/IP/VLAN/QinQ
  • Advanced Counts: Up to 8 filters at MAC, IP, TCP/UDP, Arbitrary

E1 Features

  • Port A: Coaxial Pair Impedance: 75 Ohm BNC unbalanced and 120 Ohm RJ-45 balanced
  • Port B: Symmetrical Pair Impedance 120 Ohm RJ-45 balanced
  • Analogue voice frequency audio port.
  • Additional balanced secondary E1 port 0 to -6dB, nominal and PMP -20dB
  • Operation: Terminal, Through and Monitor
  • Bit Rate: 2048 Kbit/s (+/- 3ppm)
  • Codes: HDB3 / AMI
  • Unframed
  • PCM31: FAS / FAS+CRC4
  • PCM30: FAS+CAS / FAS+CRC
  • Force Single Error: Bit, Frame, CRC, and BPV (Bipolar Violation)
  • G.826, G.821, and M.2100
  • RTD and VF tone generation
  • One-way Delay (GPS accuracy)
  • Alarms and errors count, and generation

Jitter Wander Features

  • ITU-T G.823 compliant (jitter)
  • Overpass O.172
  • Jitter level, tolerance, transfer
  • Event detection
  • 100% digital based generation and analyzer
  • Wander Generation and Measurements (TIE, MTIE, TDEV)
  • Wander results from 20 to 100 000s

Datacom Features

SC-Ether-Genius-sync

  • Smart Serial 26p DTE / DCE ports
  • V.11/X.24, V.24/V.28, V.24/V.35, V.24/V.11 (V.36/RS449), EIA530 and EIA-530A
  • Codirectional according G.703
  • Rate: 50, 60 bit/s, 1.2, 2.4, 4.8, 8, 9.6, 16, 19.2, 32, 48, 72, 128, 144, 192, 1544 kbit/s
  • N x 56 kbit/s (N=1 to 27); N x 64 kbit/s (N=1 to 32), up to 10 Mbit/s
  • DTE, DCE emulation and monitor

C37.94 Measurement

  • Test Rate: N x 64 kbit/s, N = 1 to 12
  • Configuration of internal, recovered clock
  • Frame/Unframed BER test patterns
  • ITU-T G.821 performance: ES, SES, UAS, DM
  • Results with pass / fail indications Test pattern generation / analysis
  • Frequency (Hz), Deviation (ppm), Max deviation
  • Round Trip Delay (ms)
  • One-way Delay synchronized with GPS (us)
  • Optical Power Meter
  • Defects: LOC, AIS, LOF, RDI, LSS, All 0, All 1
  • Anomalies: FAS, TSE, Slip

Users

  • LTE operators
  • Power utilities
  • Telecom Installers and Operators
  • Network Clock manufacturers
  • Triple Play service providers
  • R&D, Universities, Labs
  • Commission / Maintenance